Bowflex Max Trainer M7 Service Manual page 130

Note: Left Fan Cover is hidden for image clarity.
5. Using a #2 Phillips screwdriver, remove the screw that attaches
the Speed Sensor.
Note: The distance of the new Speed Sensor Magnet must be the
same distance from the Fan Disc for proper operation. Be sure to
note the distance before removing the Speed Sensor Magnet.
6. Disconnect the Speed Sensor Cable noting how it was routed for
re-assembly.
Note: Do not crimp the Cables.
7. Using a #2 Phillips screwdriver, attach the new Speed Sensor. Be
sure to place it the same distance from the Pulley as the old Speed
Sensor Magnet.
8. Route the new Speed Sensor Cable under the bracket and con-
nect the cable.
9. Installation is the reverse procedure.
10. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
Speed Sensor
Cable
130
Brake
Disc
Speed
Sensor
Magnet
Brake
Disc