Bowflex Max Trainer M7 Service Manual page 75

5. Using a #2 Phillips screwdriver, remove the indicated (by
ovals) screws and only loosen the lowest indicated screw (ar-
row) from the Right Fan Cover.
6. The Right Fan Cover has a tab that needs to be pushed up-
ward to clear the loosened screw. While pushing up on the tab,
remove the Right Fan Cover from the assembly.
Note: the Power Cable is attached to the inside of the Right
Fan Cover. Be sure not to crimp the cable by placing the Right
Fan Cover close to the front of the machine.
To assist with assembly, note that the
upper screw is a machine screw and
not a self-tapping screw.
7. Remove the indicated Cap from the machine.
8. Using a 6mm hex wrench, remove the hardware exposed
from below the Cap.
9. Slide the Left Leg Assembly off of the machine.
Power Inlet
75
Power Cable
Leg Assembly
Cap