Bowflex Max Trainer M7 Service Manual page 133

5. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws from the Right Fan Cover.
6. The Right Fan Cover has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the
Right Fan Cover from the assembly.
7. Remove the indicated Cap from the left side of the machine.
8. Using a 6mm hex wrench, remove the hardware exposed from
below the Cap from the left side of the machine.
9. Slide the Leg Assembly off of the machine.
Leg Assembly
Cap
10. Using a #2 Phillips screwdriver, remove the indicated screw from
the Rear Shroud.
11. Carefully remove the Rear Shroud from the machine. Place a
standard screwdriver behind and near the middle of the Rear Shroud
and gently pry until it releases. Then move the screwdriver to the
bottom and gently pry until the Rear Shroud comes off.
Rear Shroud
12. Remove the indicated Cap from the machine.
Cap
133