Bowflex Max Trainer M7 Service Manual page 81

5. Using a #2 Phillips screwdriver, remove the indicated (by oval) screw and
only loosen the lowest indicated screw (arrow) from the Left Fan Cover.
6. The Left Fan Cover Assembly has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the Left Fan
Cover Assembly.
7. Remove the Left Fan Cover Assembly from the machine. Be sure to note
how the fan screens are set into the Left Fan Cover to assist with the replace-
ment procedure.
8. Remove the Cone from the Fan Assembly. There are 4 clips that attach the
Cone that can be accessed behind the Fan Assembly. Using a small standard
screwdriver, gently release the clips.
9. Using a 5mm hex wrench, remove the 4 screws from the Fan Assembly. Be
sure to support the Fan Assembly when removing hardware.
10. Installation is the reverse procedure.
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Cone
Fan Assembly
Screws
81
Fan Assembly