Kohler VIA Series Installation Instructions Manual page 22

Installation For In-wall Tank Without Frame
A. Installation of In-wall Tank
A.
1. Remove in-wall tank from packing box. Remove cover
board inside water tank first as shown. Then remove
support block and plug above bracket assembly.
1.
2. Make sure of h according to dimensions of bowl and then
locate the installation hole of fixing bracket. Mark on the
wall for appropriate position for fixing bracket, and drill four
holes with diameter of 10mm and depth of 80mm with
churn drilling as shown in illustration, and fill in the holes
with bulge screw and tighten the screw to set the fixing
bracket.
Note: 1. Ensure the fixing bracket to remain level.
2. Cut the syphon 0~70mm short if necessary.
2.
10mm 80mm
O
1.
2.
3. Put the tank onto the fixing bracket as shown in the right
figure and adjust the tank to level . Then tighten screws
with hex-head key.
Note: it is a must to keep the tank level.
3.
4. Connect with overflow pipe on the side when installing
K-78076K-PNE/K-78078K-PNE.
4. K-78076K-PNE/K-78078K-PNE
1288805-T01-B
h
0~70mm
Plug
h
Syphon
-17-
Cover
Supporting Board
Bulge Screw
Fixing Bracket
Gasket
Level
Tank
Loosen
Tighten
Medium
Allen Key
Screw
Overflow Pipe
Cover
Spring
Nut