Kohler VIA Series Installation Instructions Manual page 14

4. According to different faceplates,there are different
installations of access panel as below.
4.
1) K-20341T-PNE/K-75890T-PNE Access Panel
Installation Methods:
There are three ways to install access panel:
Method one: Press from front
Method two: Remote plate installation: fix four plates
with screws
Method three: Remote installation of mask
1) K-20341T-PNE/K-75890T-PNE
A. Method one: Install mask when pressing from front
a) Install the mask in the block screen of the tank, and
tighten the screw to fix the mask to the tank.
A.
a)
b) Cut apart the cable of the air hose and pull it out
from the mask.
b)
B. Methods two and three: During remote installation, fix
the cover onto the tank and pull the air hose to the
panel. Reserve access panel at front to ensure
removal and installation of cover.
B.
Method two: During remote plate installation,
7~20mm thickness is recommended for the wall of
the pinch plate and at least 80mm gap is reserved.
Recommended installation hole size of
+2 +2
297 X 157 mm to remote plate installation.
0 0
Method three: During remote installation of mask, 4
holes with diameter of 10mm and depth of 16mm are
needed to be reserved at the locating hose. Drill
10mm holes through air hose on the side of mask.
7~20mm
+2
297 X
0
4 10mm 16mm
1288805-T01-B
:
80mm
+2
157 mm
0
Method one:
Press from front
18~62
Protective Cover
Cable
Pinch plate
Supporting
Board
Air hose
10mm
-9-
Method two:
Remote plate installation
Suggested faceplate Suggested faceplate
installation area installation area
R1000mm
Pinch
plate
Air hose
Screw
Cover
Air hose
10 Depth 16,
Space reserved
10 16
7~20mm recommended
7~20mm
Finished wall
At least 80mm gap reserved
80mm
+2
297
0
Method three:
Remote installation
of mask
R1000mm
Air hose
Mask
Water Tank
Fix Mask Onto Wall
Finished
wall
72
+2
157
0