Troubleshooting - Stoelting Endura 131 Service Manual

Troubleshooting can be difficult. The TROUBLESHOOTING INDEX below gives a list of possible problems.
To make a repair to a problem, make reference to the cause and correction on the page indicated. ALL REPAIRS
MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN.
This list of problems, causes and corrections will only give an indication of where a possible problem can be and
what repairs are needed. Normally, more or other repair work is needed beyond the recommendations in the list.
Remember that a problem is not normally caused by only one part, but by the relation of one part with other parts.
This list is only a guide and cannot give all possible problems and corrections. The technician must find the problem
and its source, then make the necessary repairs.
Any problem correction proceeded with an asterisk (*) may require refrigeration system repair. Refrigerant
recovery, refrigeration system repair and handling/disposal of defective refrigeration components shall be in
compliance with Environmental Protection Agency requirements per the provisions of the U.S. Clean Air Act.
In the event the Troubleshooting Guide does not help to correct the service problem, the factory Service Department
should be contacted. Contact:
STOELTING, INC.
502 Hwy. 67
Kiel, WI 53042
Subsection & Title
6.1 Dispensing,
Servability and Overrun
6.2 Barrel and Hopper Mix
Temperature
Maintenance
6.3 Electro-Mechanical
SECTION 6

TROUBLESHOOTING

Problem
No.__ Problem Description
6.1.1 Product dispenses slowly or not at all
6.1.2 Product is too soft
6.1.3 Low overrun
6.1.4 Mix spray when spigot is opened
6.2.1 Hopper temperature is too warm
6.2.2 Frozen product on hopper walls
6.2.3 Overnight barrel meltdown did not occur
6.2.4 Overnight barrel temperature is too warm
6.3.1 Freezer starts immediately after power is turned on
6.3.2 Freezer will not start after power is turned on
6.3.3 Red CLEAN light is flashing
6.3.4 HOLD READY switch will not work
6.3.5 Compressor will not start
6.3.6 Compressor will not start: hums but trips
on overload protector
6.3.7 Compressor starts, but remains on start winding
6.3.8 Compressor starts and runs, but short cycles
on overload protector
6.3.9 Compressor start capacitor open, shorted or blown
6.3.10 Compressor run capacitor open, shorted or blown
6.3.11 Compressor start relay defective or burned out
6.3.12 Compressor will not run but drive motor runs
6.3.13 Freezer refreezes too often in green light mode
6.3.14 Freezer operates too long or continuously
6.3.15 Freezer is noisy
47
Phone: 920-894-2293
Fax: 920-894-7029
Page
6-2
6-2
6-3
6-3
6-3
6-4
6-4
6-4
6-4
6-5
6-5
6-5
6-5
6-5
6-5
6-6
6-6
6-6
6-6
6-6
6-6
6-7
6-7