Removing Front Door - Stoelting Endura 131 Service Manual

To disassemble the freezer, refer to the following steps:
A. Remove the mix inlet regulator from the hopper by
pulling straight up.
B. Remove the front door by turning off the circular
knobs and then pulling the front door off the studs
(Fig.19).
Figure 19. Removing Front Door
C. Remove the rosette caps from the front door. Push
the spigot body through the bottom of the front door
and remove. (Fig. 20).
Figure 20. Front Door Disassembly
D. Remove the front auger supports and bushings
(Fig. 21).
Figure 21. Removing Auger Supports
E. Remove the auger assemblies from the freezer. Pull
the augers out of the freezer barrel slowly. As the
augers are being pulled out, carefully remove each of
the plastic flights with springs.
F. Keep the rear of the auger shafts tipped up once they
are clear of the freezer barrels to avoid dropping rear
seals (Fig. 22.)
Figure 22. Auger Shafts
G. Wipe socket lubricant from the drive end (rear) of the
auger with a cloth or paper towel.
H. Remove the rear seals.
I. Remove all "O" Rings from parts by first wiping off the
lubricant using a clean paper towel. Then squeeze the
"O" Ring upward with a dry cloth (Fig. 23). When a loop
is formed, roll out of the "O" Ring groove.
12