Table of Contents
Advertisement
5. Remove the two electrical wires from the interlock
switch (Figure 56).
Figure 56. Interlock Switch Removal
6. Remove the two Phillips pan head screws that hold
the switch bracket located below the header panel.
7. Measure and note the position of the switch relative
to the bracket. Remove the switch from the bracket.
5.11 FRONT DOOR INTERLOCK
SWITCH ASSEMBLY
1. Assemble the replacement switch to the bracket and
secure in the same position as the old one.
2. Position the switch and bracket assembly in the
electrical box and secure with the two Phillips pan
head screws.
3. Use a V.O.M. (Volt Ohmmeter) to check the operation
of the switch when the front door is installed (Figure
57).
Figure 57. Interlock Switch Assembly
4. Attach the two electrical wires to the common and
normally open terminals.
5. Position the spigot handle assemblies in the electrical
box and secure with the Phillips head screws.
6. Replace the spigot adjuster knob and tighten.
7. Install the decorative headed panel and secure with
the two Phillips head screws.
5.12 TOUCH PAD SWITCH MODULE
The touch pad switch module contains a series of "snap"
switches to control freezer functions.
5.13 TOUCH PAD SWITCH MODULE
REMOVAL
1. Use a 5/64" Allen wrench to remove the retaining
screw located at the bottom of the module.
2. Remove the module from the housing by gently
prying the bottom out with a small packet screwdriver.
3. To open the connector labeled J3 insert a small
pocket
screwdriver
counterclockwise, then pull out the ribbon (Figure
58).
Figure 58. Switch Module Removal
4. Remove the four screws holding the circuit board to
the module and separate.
38
and
carefully
twist
Advertisement
Table of Contents
