Drive Motor Installation; Motor Pulley Adjustment - Stoelting Endura 131 Service Manual

1. Loosen the belt tension adjusting nut and remove the
drive belt (Figure 65).
Figure 65. Drive Belt Removal
2. Remove the four bolts holding the drive motor to the
mounting plate.
3. Turn the motor and remove the electrical cover plate.
Identify and disconnect the four electrical wires
(Figure 66).
Figure 66. Drive Motor Wire Removal
4. Use an Allen wench to loosen the pulley setscrew.
Remove the pulley and key.
5.24

DRIVE MOTOR INSTALLATION

1. Fit the key and pulley to the replacement motor.
2. Remove the cover plate and connect the four
electrical wires, the replace the cover plate.
3. Install the motor on the mounting plate and secure
with the four bolts. Align the motor on the mounting
plate and tighten the four bolts.
4. Align the motor pulley to the top pulley and tighten
the setscrew (Figure 67).
Figure 67. Motor Pulley Adjustment
You must have proper alignment or short belt life
will result.
5. Install and adjust belt to the proper tension (Figure
68).
Figure 68. Belt Tension Adjustment
42
NOTE