Front Door And Auger Assembly; Rear Seal Assembly - Stoelting SC118 Owner's Manual

To disassemble the freezer, refer to the following steps:
A. Remove the front door by removing the upper and lower
plastic shrouds then turn off the knobs, and pull the
front door off the studs.
B. Remove the spigot body from the spout by pulling the
horse shoe clip up and out. Then pull the spigot body
out of the spout. Disassemble by turning off the black
plastic knob and removing all loose pieces.
C. Pull the agitator assembly out of the freezer barrel.
D. Keep the rear of the agitator assembly tipped up once
it is clear of the freezer barrel to avoid dropping rear
seal.
E. Remove the front agitator support bearing and the two
agitator blades.
F. Remove the rear seal assembly and disassemble.
G. Wipe socket lubricant from the drive end (rear) of the
agitator with a cloth or paper towel.
Figure 7. Front Door and Auger Assembly
H. Remove all "O" Rings.
6
WARNING
DO NOT USE ANY TYPE OF SHARP OBJECT TO
REMOVE THE "O" RINGS.
Figure 8. Rear Seal Assembly