Sensor Adjustment; Manual Mode; Digital Inputs - Wolf WRS-K Installation And Operating Instructions Manual

Sensor adjustment

Sensor adjustment
Room temperature
Esc BACK SELECTION

Manual mode

(condition: system switched OFF)
Manual mode
Ventilation fan
Stage 1 :
Stage 2 :
Stage 3:
DISPLAY SELECTION

Digital inputs

Digital inputs
Fault, inv. vent. fan
ID15 KLM - M/L
Fault, EC mtr, vent air
ID--
Esc BACK SELECTION
3062878_201707
10. Operating level 2
Here, sensor corrections can be carried out.
Parameter
Room temperature
FA-01
Vent. air temperature
0.0 K
Extract air temp
Outside temperature
DISPLAY
Icing-up temp
Ventilation air humidity
Rel. humidity (room)
Rel. hum., extract air
Air quality CO
Diff. pressure sensors, supply
air
Diff. pressure sensors, extract
air
Here, every drive can be activated manually.
Please note
HB-02
OFF
OFF
In the case of flaps that can be either only open or closed, the fan activation
parameters will only be displayed when the flaps are open.
OFF
Esc BACK
Here, all digital inputs (faults, operating messages) are displayed with their current
status (contact closed or contact open).
DE-01
DISPLAY
Setting range
-5 - 5 K
-5 - 5 K
-5 - 5 K
-5 - 5 K
-5 - 5 K
-20 - 20 % r.h.
-20 - 20 % r.h.
-20 - 20 % r.h.
-200 - 200 ppm.
2
-100 - 100 Pa
-100 - 100 Pa
As a safety precaution, the parameters for activating the electric
heater bank or the direct evaporator are only shown when the fan
runs (in the case of single stage fans, this must receive a control
signal of at least 2 V).
Factory setting
0 K
0 K
0 K
0 K
0 K
0 % r.h.
0 % r.h.
0 % r.h.
0 ppm.
0 Pa
0 Pa
29