Page 1 Configuration wizard WRS-K WOLF GMBH / POSTFACH 1380 / D-84048 MAINBURG / TEL. +49(0) 87 51 74- 0 / FAX +49(0)87 51 74- 16 00 / www.WOLF.eu Part no.: 3062933_201707 Subject to technical modifications...
Page 2: Table Of Contents
Contents Contents ........................2 Installation / commissioning / operating overview ............ 3 Post-configuration, air quality / CO sensor .............. 4 Post-configuration remote control................5 Post-configuration, LON / BacNet / ModBus / Ethernet / KNX interface ....6 Post-configuration, pressure control / flow rate control / cooling function ....7 New configuration controller ..................
Page 3: Installation / Commissioning / Operating Overview
- DIN VDE 0100 regulations regarding the installation of high voltage systems up to 1000 V. - DIN VDE 0105-100 operation of electrical systems. - Only original Wolf accessories may be used (electric heater bank, condensate pump, servomotors, etc.), otherwise, Wolf cannot provide a warranty.
Page 4: Post-Configuration, Air Quality / Co Sensor
Enter Enter Other Air quality sensor available? >Yes U08 KLM-M/L Type 0-10V Version VOC wolf-heiztechnik.de Esc BACK SAVE DISPLAY Use Enter to confirm the input port "U8" and type "0-10 V" to select the variant "VOC" or Continue with "CO2"...
Page 5: Post-Configuration Remote Control
DISPLAYS Esc BACK SELECTION DISPLAY Select "Heating contractor" with Select "Remote control" with confirm with Enter confirm with Other... Remote control installed? wolf-heiztechnik.de Esc BACK SELECTION DISPLAY Select "Yes" with and confirm with Continue with Enter Contractor Password: 1234 Configuration...
Page 6: Post-Configuration, Lon / Bacnet / Modbus / Ethernet / Knx Interface
Esc CANCEL SAVE VALUE SELECTION Esc BACK DISPLAY Confirm with Select "Heating contractor" with confirm with Enter Other... Protocol type: BacNet wolf-heiztechnik.de Esc CANCEL SAVE VALUE Continue with Select required connection with Contractor No proto pCO Manager LON-Works Bac-Net Password: 1234...
Page 7: Post-Configuration, Pressure Control / Flow Rate Control / Cooling Function
SELECTION DISPLAY Esc BACK SELECTION DISPLAYS Select "Heating contractor" with Confirm with confirm with Enter Other... Remote control installed? wolf-heiztechnik.de Esc BACK SELECTION DISPLAY Select "Yes" with and confirm with Enter Continue with Contractor Password: 1234 Select 1234 with and confirm with...
Page 8: New Configuration Controller
New configuration control unit 6. To make an individual control adjustment, you must go through the whole system configuration process. Configuration Please wait... System configuration in preparation Esc CANCEL SAVE VALUE Operation (selection) is carried out with the arrow keys , the selected function is confirmed with Enter , and then the...
Page 9 New configuration control unit Configuration Factory setting Customer setting Heating: Electric heater bank Depending on variable order DHW pump bank Please select Esc CANCEL SAVE VALUE Select heating mode: No heating DHW pump bank El heater bank stage 1 El heater bank stage 2 El heater bank stage 3 El heater bank stage 4 El heater bank stage 5...
Page 10 New configuration control unit Configuration Factory setting Customer setting CKL / CFL Please select Esc CANCEL SAVE VALUE Select heat recovery system: No HR available Coil loop without feed Coil loop + heat feed Coil loop + cold feed Coil loop + heat/cold feed Configuration Factory setting Customer setting...
Page 11 New configuration control unit Configuration Factory setting Customer setting Ext. demand: Remote ON/OFF + stages Please select VALUE Esc CANCEL SAVE Select external systems, demand: None available Remote start/stop Remote step control Remote ON/OFF + stages 3062933_201707...
Page 12: System Configuration
System configuration Configuration Factory setting Customer setting Remote control None available Please select VALUE Esc CANCEL SAVE Select remote control: None available Set value transducer Remote control Configuration Factory setting Customer setting Humidif. None available Please select VALUE Esc CANCEL SAVE Select humidification: Not available...
Page 13 System configuration Configuration Factory setting Customer setting Reheating No reheating Please select VALUE Esc CANCEL SAVE Select reheating: No reheating DHW pump bank El heater bank stage 1 El heater bank stage 2 El heater bank stage 3 El heater bank stage 4 El heater bank stage 5 El heater bank, variable Configuration...
Page 14 System configuration Overview of the preset configuration Configuration Vent./ex. air syst. w/ Variable speed fan DHW pump bank No cooling bank Outs./dis. air dampers Continue with Enter Continue with Configuration Heat recovery PHE Ext./vent. air cascade Outside/extr. air fltr 1 fire damper Remote start/stop Continue with Enter Continue with...
Page 15: Configuration For Pressure Or Flow Rate Control
Configuration for pressure or flow rate control The following settings should be made on site for pressure control. Step 2 Selecting the number of pressure sensors Standard screen → → Select heating contractor → Enter password 1234 → Select pressure/flow rate Pressure/flow rate ctl Factory setting Customer setting...
Page 16 Configuration for pressure or flow rate control Step 3 Enter set values for automatic mode Standard screen → → Select time functions → Set values → Select pressure control, supply air → Enter values → Select pressure control, extract air → Enter values Select "Pressure control, ventilation air"...
Page 17 Configuration for pressure or flow rate control Step 4 Set value for backup mode, heating/cooling Setting night ventilation and peak ventilation Standard screen → → Select heating contractor → Enter password 1234 → Select backup mode → Select heating pressure → Enter value Backup mode Factory setting Customer setting...
Page 18 Configuration for pressure or flow rate control Step 5 Entering a set value for manual mode Standard screen → → Standard settings → Select vent. air fan pressure, manual mode → Set value Factory setting Customer setting Standard setting 100 Pa Vent.
Page 19: Notes
Notes 3062933_201707...
Page 20 WOLF GmbH Postfach 1380 · D-84048 Mainburg · Tel. +49-(0)8751/74-0 · Fax +49-(0)8751/741600 Internet: www.wolf.eu 3062933_201707 Subject to technical modifications...

Wolf WRS-K Configuration Manual

Quick Links

Related Manuals for Wolf WRS-K

Summary of Contents for Wolf WRS-K

Table of Contents