Initial Commissioning Of End Devices Using The Wbm - Siemens SINEMA Remote Connect Operating Instructions Manual

3.3

Initial commissioning of end devices using the WBM

Commissioning and devices via the WBM:
Follow these steps:
1. Configure the new device on the SINEMA RC Server. For more detailed information, refer
to the section Create new device (Page 68).
– Specify the required device information. e.g. device name, manufacturer, location etc..
– Configure the VPN connection mode
– Enter the password to identify the end device during the logon.
– Assign the device to a participant group. For more detailed information, refer to the
When the device is configured, the certificate is created automatically. For more detailed
information, refer to the section Overview of certificate management (Page 87).
2. Configure the device.
– To identify the device to the SINEMA RC Server, transfer the certificate to the device
– Enter the IP address of the SINEMA RC Server.
3. Put the device into operation.
Result
The device connects to the SINEMA RC Server. When the connection has been successfully
established, a virtual IP address for example is transferred.
If necessary, perform further configuration steps:
1. At the device end: e.g. creation of firewall rules, NAT
You will find precise step-by-step instructions in the Getting Started for SINEMA Remote
Connect and in the Getting Started of the relevant device.
SINEMA Remote Connect - Server
Operating Instructions, 11/2017, C79000-G8976-C383-04
section Assigning a node to a group (Page 77).
and enter the password.
3.3 Initial commissioning of end devices using the WBM
Installation and commissioning
33