Display Assembly - HP OMEN 15-ce100 Maintenance And Service Manual

Display assembly

IMPORTANT:
and replacement
Before removing the display assembly, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
c. Fans (see
d. Heat sink (see
e. System board (see
Remove the display assembly:
1. Disconnect the display panel cable from the system board (1).
2. Disconnect the WLAN antenna cable from the system board (2).
3. Release the WLAN antenna cable from the clips securing it to the computer (3).
4. Open the computer with the bottom facing up (1).
5. Remove the four Phillips PM2.5×5.7 screws (2) securing the display assembly to the computer.
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
Fans on page 49).
Heat sink on page
System board on page
36), and then remove the following components:
45).
System support brackets on page
53).
58).
46).
Component replacement procedures 61