Power Button Board - HP OMEN 15-ce100 Maintenance And Service Manual

Power button board

NOTE: The power button board does not include the power button board connector cable.
Description
Power button board
Power button board connector cable
IMPORTANT:
and replacement
Before removing the power button board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
c. Fans (see
d. Heat sink (see
Remove the power button board:
1. Disconnect the power button board cable from the system board (1).
2. Remove the two Phillips PM2.0×3.5 screws (2) that secure the power button board to the computer.
56 Chapter 6 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
Fans on page 49).
Heat sink on page
36), and then remove the following components:
45).
System support brackets on page
53).
Spare part number
929468-001
929448-001
46).