Siemens SIPART PS2 6DR50xx Manual page 142

Operation
Messages on exiting configuration mode:
4.nn.nn x
VER x
Error x
SLnn
x
Messages during operation:
CPU x
START x
HW / x
ERROR
NOINI x
nnn.n x
AUTnn x
MANnn
oFL / 127.9 x
EXSTP x
EX UP x
EXDWN x
EXTPSt
InPSt
HTCNF x
142
Meaning/cause
Software version
Monotony violation of the
free characteristic curve at
vertice n
Meaning/cause
Message after applying the
electrical power supply
Hardware error
x Positioner is not initialized
x x Actual position [in %] with
initialized positioner. Flashing
decimal point indicates com-
munication with a class 2
master
x Automatic mode
(nn = setpoint)
x Manual mode (nn = setpoint)
x x Display range was exceeded.
Possible causes:
friction clutch or
S
transmission ratio selector
S
were misadjusted or
positioner was fitted on
S
another actuator without
re-initialization.
x Actuator was stopped via
binary input
x Actuator is moved to the
upper stop via binary input
x Actuator is moved to the
lower stop via binary input
Partial stroke test was
activated e.g. via binary input
cyclic partial stroke test
x x x HARD configuration running
Measure
Wait
S
Correct value
S
Measure
Wait
S
Replace electronics
S
Start initialization
S
Press operating mode
S
button to switch to
automatic mode
Adjust friction clutch in
S
such a way that the
indication of the actual
value remains between
0.0 and 100.0 on
moving the actuator or
switch over the
S
transmission ratio
selector or
set to the factory setting
S
(preset) and initialize
SIPART PS2 Manual
A5E00074631--06