Alamo MACHETE Product Service Manual page 128

MOTOR P/N 02979881 - ASSEMBLY
Motor Assembly: Continued
15
Install Cylinder Barrel. When installing the
cylinder barrel (item 15), it must be timed.
There are punch marks on the Shaft Gear and the
gear of cylinder barrel, these marks must be
aligned as shown below. (See Figure 32) Set this
assembly aside for now.
16.
Install Valve Plate, Coat Valve plate (item
2) with a coat of grease (See Figure 33) will be to
hold valve plate in housing during assembly. With
the Barrel Hosing assembly in vise install the valve
plate into it. This plate must be installed with the
correct side down and the correct side up. (See
Figure 34). Note the location of the notch in OD of
valve plate.
Install Barrel Housing. Clamp Bear
17.
housing and Shaft assembly back into the vice.
With the barrel housing assembly turned up as
shown in figure 35. Make certain the Valve plate
(item 2) is installed inside the barrel housing and
facing the correct direction. Make certain the Shims
(item 24) are still installed on the Bearing housing.
Sit the barrel housing (item 1) down over the
bearing housing (item 6). Install the four bolts (item
25), and Torque these four bolts using an alternat-
ing pattern to 75 ft. lbs. +/- 7 ft lbs (See Figure 36)
Figure 31
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Figure 29
ing
Figure 30
24
Figure 32
128
17 & 18
16
15