Alamo MACHETE Product Service Manual page 104

MOTOR P/N 02967193 - DISASSEMBLY
Critical
Sealing
Area
FIGURE 62
8. When removing or installing Bearing Cone, DO NOT damage Output Shaft Sealing area
(Stepped area between Bearing Journal and Output Shaft Splines) This area is critical for
sealing Output Shaft Seal (Figure 62).
9. Use suitable Bearing Puller or Punch to remove Bearing Cup from Main Housing (Figure 63)
10. Reposition Cylinder Barrel and Swash Plate so that Swash Plate is in down position. Use 1/4"
Hex Key to remove Cap Screws from retaining straps on one side of Swash Plate. Loosen Cap
Screws on other Retaining Strap; this will make it easier to remove Cylinder Barrel from Swash
Plate (Figure 64)
11. Carefully reposition Cylinder Barrel and Swash plate in the Up position. Remove Swash Plate
by lifting it slightly and sliding it over to dis-engage from retaining Strap.
12. Remove Cap Screws, retaining Strap, Spacers and Thrust Plate from Swash Plate (Figure 64).
13. Dis-Assemble Cylinder Barrel Assembly; Place it on a clean protective surface for inspection
and cleaning.
Bolts
Retaining
Strap
Spacers
FIGURE 63
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Note: See Bearing
Cone removel Tool
(Figure 59)
Swash
Plate
FIGURE 64
FIGURE 63
Piston /
Thrust
Slipper Asy
Plate
104
To Drive Out
Bearing Cup
Drift
Punch
Main
Housing
Cylinder
Barrel Asy