Alamo MACHETE Product Service Manual page 127

MOTOR P/N 02979881 - ASSEMBLY
Motor Assembly: Continued
11
. Install O-Ring Seal. Install the O-Ring
Seal (item 7) into bearing housing (See
Figure 28).
12.
Install Pistons & Piston Rings. Coat
the pistons (item 17) with hydraulic oil, make
certain all 7 pistons have 3 rings (item 18)
each on them. (See Figure 29). Piston will lay
over to the side as shown in figure 29 but will
slip down into the holes as shown in Figure
30.
13.
Install Barrel Support. The Barrel Sup-
port (item 16) is a 4 piece assembly that
installs in the center of the shaft, make certain
all components of the barrel support is in-
stalled. (See Figure 30)
14.
Install Shims.
housing shims (item 24) onto bearing hous-
ing (See Figure 31), These shims are various
thickness and the quantity required will vary,
start with the same amount and thickness
that was removed.
Figure 27
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Install the bearing
Splined
Shaft
12
Figure 25
Figure 26
Figure 28
127
Seal
Driver
Seal
Seal
Carrier
Splined
Shaft
9 & 10
7