Alamo MACHETE Product Service Manual page 121

MOTOR P/N 02979881 - DISASSEMBLY
Motor Disassembly: Continued
4.
Lift Out Barrel Support . Lift the barrel
support out (item 16), make certain that all the parts
in barrel support are accounted for. (See Figure 5)
5
. Remove the Pistons (item 17), there are
7 pistons and 21 piston rings (item 18) that will
be removed. There are 3 piston rings per piston.
(See Figure 6)
6.
Remove Bearing Housing Sealing O-Ring.
There is an O-Ring (item 7) that is used to seal
barrel housing assembly (item 1) to bearing hous-
ing (item 6). Remove this O-ring (See Figure 7)
This will leave Shaft Assembly (item 14) still in
Bearing housing (item 6)
7.
Remove Retaining Snap Ring. Remove the
Bearing Housing Assembly from vise and turn it
over so the shaft end is pointing upward and re-
clamp it into vise as shown in figure 8. Using
internal Snap Ring pliers to remove the snap ring
that retains the seal carrier (item 9). Note: Smooth
Shaft shown, actual shaft is splined in this motor.
7
Figure 7
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Figure 5
Figure 6
6
Figure 8
121
16
17
Splined
Shaft
12