Installing The Router - Cisco IR800 Series Hardware Installation Manual

3
C H A P T E R

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the IR807 and contains
the following sections:
• Installing the Router, on page 25
Installing the Router
This chapter describes the equipment and the procedures for successfully installing the IR807 and contains
the following sections:
Before installing the IR807, make sure you have read and understood all of the information included in the
documentation included with the product. An on-line version is also available here:
http://www.cisco.com/c/dam/en/us/td/docs/routers/access/800/807/GettingStarted/78-101247.pdf
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating
vents.
WARNING: Read the installation instructions before connecting the system to the power source. Statement
1004
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care not to come
into contact with such circuits, because they may cause serious injury or death. For proper installation and
grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National
Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
WARNING: This product is not intended to be directly connected to the Cable Distribution System. Additional
regulatory compliance and legal requirements may apply for direct connection to the Cable Distribution
System. This product may connect to the Cable Distribution System ONLY through a device that is approved
for direct connection. Statement 1078
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
25