Connecting the Router
7.
8.
Verifying Connections
To verify that all devices are properly connected to the router, first turn on all the connected devices, then
check the LEDs. To verify router operation, refer to the
Use a ratcheting torque flathead
screwdriver to torque the power
connector captive screws (above
the installed wire leads) to 2 in-lb
(0.23 N-m).
Connect the other end of the
positive wire to the positive
terminal on the DC power source,
and connect the other end of the
return wire to the return terminal
on the DC power source.Connect
the other end of the Alarm wires to
your alarm source.
Front Panel Icons and LEDs, page 10
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
Verifying Connections
.
39