Cisco IR800 Series Hardware Installation Manual page 35

Installing the Router
1.
2.
3.
4.
5.
6.
Locate the ring terminal lug and
screws in the packaging kit. Store
the ground screws for later use.
Use a wire stripping tool to strip
the 14 or 18 AWG (1.6mm or
1.02mm) grounding wire to 0.22
in. (5.56 mm).
Insert the ground wire into the ring
terminal lug, and using a crimping
tool, crimp the terminal to the wire.
Insert the ground screws (2) into
the grounding lug (1) shown in the
graphic and attach the lug to the
router.
NOTE: if your grounding lug is a
single hole type, attach it in the
same manner as the dual hole using
the first hole from the front panel.
Use a ratcheting torque screwdriver
to tighten the ground screw and
ring terminal to the router side
panel to 3.5 in-lb (0.4 N-m). The
torque should not exceed 3.5 in-lb
(0.4 N-m).
Attach the other end of the ground
wire to a grounded bare metal
surface, such as a ground bus, a
grounded DIN rail, or a grounded
bare rack.
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
Installing the Router Ground Connection
33