Write - Omron V700 series Operation Manual

(2) Write

The Write command is used when data is to be written onto the Tag Memory
in units of pages. Data can be written on any specified page. The maximum
number of pages onto which data may be written at one time is 16.
n Command
The pages to be written on, as parameters and the data to be written onto each
page will be transmitted. Page specifications shall be made by specifying the bit
indicating the page as "1" and the other bytes as "0". This binary is converted to a
hexadecimal and transmitted as a command. Data to be written should be
specified in the order of specification of the designated pages.
Command Option
"0" "2"
Bit 7 6 5
Page 30 29 28 ~ ~
Value "00" ~ "FF"
* Data number n = specified page x 8 (2 characters each in Hex data, one
character each in ASCII code)
** 0, 1 bits should be specified as "0". When "1" is specified, it will be regarded
as an error (error code 14).
n Response
The completion code ("00" when successful) will be transmitted.
Completion
code
"0" "0"
<Command Example>
When writing 2 pages of data onto pages 8 and 9 using the FIFO repeat
mode with ASCII specification:
021B00000600 (Data on page 8) (Data on page 9) [CR]
Page specification (8 characters)
1 0 7 6 1
24 23 22 21 ~ 16 15 14 13
"00" ~ "FF"
Terminator
CR
(000000000000000000000011000000000b)
Data to be written*
(Data 1)
0 7 6 1 0
~ 8 7
"00" ~ "FF"
(17/30)
⋅ ⋅ ⋅ CR
(Data n)
7 6 2 1 0
6 5 ~ 1 ** **
"00" ~ "FC"