Transmission Operations - Omron V700 series Operation Manual

(2) Transmission Operations

The following 6 transmission operations are executed by changing the
process procedure and execution timing. Transmission operations are
specified by commands during command transmission.
1) Single Trigger
Transmission with Tag is executed immediately after receiving command
and a response is transmitted. After response is transmitted, the Reader
Writer will be on stand by for new commands. During transmission with
the Tag, there must be only one Tag within the transmission area.
♦ Operation Sequence
Processing is executed once only after receiving command. If there is no
Tag, a Tag absent error message will be transmitted.
High-end→ Command
←High-end
Tag
Transmission
Command Process
Tag Operation
2) Single Auto
After receiving command, the Reader Writer waits for the Tag to
approach, communicates with the Tag, and then transmits a response.
Once the response is transmitted, the Reader Writer will be on stand by
for new commands. During transmission with the Tag, there must be one
Tag within the transmission area.
♦ Operation Sequence
After receiving command, the Reader Writer waits for the Tag to
approach, then executes process once only after Tag is detected. When
the Reader Writer receives a STOP command, the command will be
completed.
High-end→
Comman
←High-end
Tag
Transmission
Tag Operation
Command
Response 1
Tag 1
Response
Command Process
Tag
Detection
Tag 1
Response 2
(Tag Absence Error)
Command Process
Comman STOP
Tag Detection
(10/30)
Response
(Termination
Process)