Completion Code - Omron V700 series Operation Manual

(3) Completion Code

The Reader Writer will return the response to the high-end unit by transmitting
a completion code. The definitions of the completion codes are as follows:
Class Completion
Code
Normal end 00
Communication 10
Error between
high-end unit
11
and Reader
Writer
12
14
18
Transmission 70
Error between
Reader Writer
and Tag
71
72
7A
7B
7D
7F
Hardware Error 7C
Name
Normal end Normal operations completed.
∗
Parity error
Framing error There is a framing error in the command
received.
Overrun error There is an overrun error in the command
received.
Format error The command format is not suitable for the
specification.
Ex) Command section is not defined;
page/address specification is incorrect, etc.
Frame length error When the receiving frame exceeds 273
characters.
When the intervals between the characters
being received exceeded 2 sec.
Transmission error Noise or other disruption occurred during
communication with Tag, and the
command cannot be executed properly.
Verification error Tag is dated or incapable of being written
correctly for physical reasons.
Tag absence error Tag is not present near antenna at time of
Trigger commands execution.
Address Page specification is incorrect.
specification error
Outside of write There is a Tag in the area where reading is
area error possible but writing is not.
Write protection Write command was executed on a page
error specified with write protection.
ID system error The Tag used is not to specification of
system.
Antenna hardware There is a hardware problem on the
error antenna.
Details
There is a parity error in the command
received.
(15/30)