Table of Contents
Advertisement
Pressure Rollers
The pressure rollers must all be the same dis-
tance away from the table surface (conveyor
track).
To adjust the pressure rollers:
1.
Disconnect the saw from the power
source!
2.
Using the blade height handwheel, raise the
bottom edge of the blade above the bottom-
dead-center of the pressure rollers.
3.
Using the pressure roller height handwheel,
raise the head of the saw high enough to
allow a flat board to be placed under all the
pressure rollers.
4.
Slowly lower the head.
— If the pressure rollers make contact with
the board at the same time, they are
adjusted correctly.
— If the pressure rollers do not make con-
tact with the board at the same time, they
need to be adjusted so they do. Continue
with the next step.
Model G0524 (Mfd. Since 7/16)
5.
Each pressure roller can be independently
adjusted by loosening the jam nut and turn-
ing the small setscrew (Figure 40). Note—
Turning the setscrew clockwise, as viewed
from the top, lowers the pressure roller; coun-
terclockwise raises the pressure roller.
Jam Nut
Figure 40. Setscrew for height adjustment.
6.
Once the pressure rollers are adjusted cor-
rectly, retighten the jam nuts.
Setscrew
-33-
Advertisement
Table of Contents
