V-Belt Tension - Grizzly G0524 Owner's Manual

— If end B is wider than end A, then the tip of
the fence needs to be adjusted to the right
to make the fence parallel to the blade
(Figure 35).
Figure 35. Adjusting the fence to the right.
3. Loosen the cap screws (Figure 36) on the
top of the fence to allow adjustment of the
fence. Retighten when complete.
Figure 36. Cap screws to loosen fence.
4. Repeat step 1 to verify that the adjustments
are correct.
Model G0524 (Mfd. Since 7/16)
A
B
Cap Screws

V-Belt Tension

To adjust the main motor V-belt tension:
1. Disconnect the saw from the power
source!
2.
Remove the side access panel to reveal the
adjustment mechanism.
3. Loosen the jam nut (Figure 37).
Jam Nut
Figure 37. Arbor motor V-belt adjustment.
4. Adjust the turnbuckle to increase or decrease
the V-belt tension. Note—Turning the turn-
buckle clockwise lowers the tension and
counterclockwise increases it.
5. Retighten the jam nut when the V-belt has
been tensioned correctly and re-install the
side access panel.
Turnbuckle
-31-