Troubleshooting Finisher Problems - Sharp AR-M355N Operation Manual

Troubleshooting finisher problems

Check the list below before calling for service.
Problem
Are any finisher covers open?
The finisher does
Message indicating need to remove
not operate.
paper
displayed?
Is a "CHECK THE STAPLER UNIT" or
"CHECK STAPLER POSITION OR
STAPLER JAM" message displayed?
Stapling cannot be
Is
performed.
displayed?
Different size paper included?
Stapled sets are not
stacked correctly or
Paper heavily curled?
some sheets in a set
are not stapled.
Check
from the stapler compiler
a message "ADD STAPLES"
Solution or cause
Close all covers.
Open the finisher
as described in
step 4 on page
3-12 and remove
all paper from the
stapler compiler.
Check the staple unit. (See page 3-11.)
Replace the staple cartridge. (See page 3-10.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside
down, and load it again.
FINISHER
3
3-13