Troubleshooting - Sharp AR-M355N Operation Manual

TROUBLESHOOTING

Problem
If too many pages collect on the output
Printing stops
tray, the tray full sensor activates and
before the job is
stops printing.
finished
You have run out of paper.
Smudges on printed Does a message appear indicating the
sheets need for maintenance?
The displayed
paper size or paper The correct paper size or paper type is
type does not match not set in the paper tray settings of the
the loaded paper custom settings.
size or paper type.
When printing on a
special size of The paper size setting is not set
paper, part of the correctly in the paper tray settings of the
printed image is custom settings.
missing.
Is
recommended paper being used?
Paper curled or damp?
Is the paper curled and does it
frequently misfeed in the finisher or
saddle stitch finisher?
Paper misfeeds
frequently.
Multiple
simultaneously?
The paper in the tray is not stacked
evenly.
2-24
Check
paper other than SHARP-
sheets of paper
Solution or cause
Remove the paper from the output tray.
Load paper. (Page 2-2)
Please contact the your dealer as soon as
possible.
When loading paper, if you change the paper
size from an inch size to an AB size, or from an
AB size to an inch size, or change the paper
type, be sure to set the new paper type as
explained in "Setting the paper type and paper
size" (see page 2-5).
When using a special size of paper, set the
correct paper size as explained in "Setting the
paper type and paper size" on page 2-5. If the
paper size setting is not correct, part of the image
may be cut off or the image may not print.
Use SHARP-recommended paper. (Page 2-16)
Do not use curled or crimped paper. If you will
not use the paper for a long time, remove the
paper from the tray and store it in the wrapper in
a cool and dark location so that it will not absorb
moisture.
Paper may be curled when output depending on
the paper type and quality.
In some cases turning the paper over in the tray
will reduce misfeeding due to curling.
fed
Make sure that the paper in the paper tray is
stacked evenly. If the stack is not even, paper
misfeeds will occur.
Remove the paper
from the paper
tray or the bypass
tray, fan the paper
as shown in the
illustration, and
then load it again.