Programming, Editing, And Deleting F-Code Memory Boxes; Boxes (Polling Times); Boxes; Times - Sharp AR-M355N Operation Manual

8 Use the numeric keys to enter a passcode
(max. 20 digits).
F-CODE MEMORY BOX / POLLING MEMORY
No.001
SUB ADDRESS / PASS CODE
ENTER THE SUB ADDRESS / PASS CODE VIA THE 10-KEY PAD,THEN PRESS [OK].
214341434/351212
G In addition to numbers, the characters "
can be used in a passcode.
G If you make a mistake, press the [C] key to clear the
mistake.
SETTING FOR
(POLLING TIMES)
You can select whether to have document data that was scanned into an F-code polling memory box automatically
cleared after one transmission, or to leave the document data in the box and allow an unlimited number of
transmissions when polled. (The initial setting is "ONCE". Change the setting as needed.)
1 Touch the [POLLING MEMORY] key in
step 3 of "PROGRAMMING AN F-CODE
MEMORY BOX" on the previous page and
store a box name, sub-address, and
passcode.
2 Touch the [POLLING TIMES] key.
BOX NAME FAX INFORMATION
SUB ADDRESS 214341434/351212
POLLING TIMES
ONCE
Touch the key for the desired polling
3

times.

If you do not wish to erase the document after
polling takes place, touch the [UNLIMITED] key so
that it is highlighted.
F-CODE MEMORY BOX / POLLING MEMORY
No.001
POLLING TIMES
ONCE
UNLIMITED

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES

NEXT EXIT
-KEY PAD,THEN PRESS [OK].
CANCEL OK
PASS CODE
" and "#"
F-CODE POLLING
NEXT EXIT
OK
9 Touch the [OK] key.
CANCEL OK
PASS CODE
to the right of the box number. (Only for F-Code
polling memory.)
Continue programming the settings that are
particular to each type of memory box. Go to
the appropriate page below:
G G G G F-code polling memory (Polling times: this
page)
G G G G F-code confidential transmission (Print PIN:
following page)
G G G G F-code
relay broadcast
(Recipient: page 6-13)
MEMORY
4 Touch the [OK] key.
You will return to the screen of step 2 and the
selected polling times will appear.
5 To exit, touch the [EXIT] key.
To program another memory box, touch
the [NEXT] key.
NEXT EXIT
screen of step 4 on page 6-10).
You will return to the
memory box programming
screen. The entered sub-
address and passcode are
displayed.
"REGISTRATION IS
COMPLETED." appears
transmission

BOXES

Touching the [EXIT] key
returns you to the screen
of step 3 on page 6-10.
Touching the [NEXT]
key returns you to the
screen for programming
a new memory box (the
6-11
6