Erasing Edge Shadows (Edge Erase); G Using Edge Erase; Using Edge Erase - Sharp AR-M355N Operation Manual

ERASING EDGE SHADOWS (EDGE ERASE)

The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it's initial
setting.
Your machine

USING EDGE ERASE

1 In fax mode, touch the [SPECIAL MODES]
key.
MODE SWITCH
ADDRESS REVIEW
SPECIAL MODES
SUB ADDRESS
FILE
TO RECEPTION
QUICK FILE
MEMORY:100%
Touch the [ERASE] key.
2
M ERASE
R
2in1
3 Select the desired erase mode.
ERASE
CENTER EDGE+CENTER
EDGE
ERASE ERASE ERASE
3-4
EDGE ERASE
Erases shadows at edges
that appear when faxing
thick originals or books.
Transmission to
CENTER ERASE
other machine
Eliminates shadow lines
produced by the bindings
of bound documents.
EDGE + CENTER ERASE
Eliminates shadow lines around
the edges of copies and
eliminates the shadow at the
center of copies.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-5).
C
Select one of the three
erase modes. The
selected key will be
highlighted.
The other machine
Using edge erase
Combining "edge erase"
with "Dual page scan" on
the following page
4 If desired, set the width of the edge to be
erased (touch the
set the width).
CENTER
(0 1)
1/2
inch
5 Touch the outer [OK] key.
OK
CANCEL OK
6 Send the fax as explained in "BASIC
PROCEDURE FOR SENDING FAXES"
(pages 2-2 to 2-3).
NOTE
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen. (step 4)
key or the key to
The erase width can be
set from 0" to 1" in 1/8" (0
to 20mm in 1mm)
increments.
You will return to the
screen of step 1 and an
edge erase icon will
appear next to the
[EXPOSURE] key.
To cancel the erase,
touch the [CANCEL] key.