G Troubleshooting (Concerning The Saddle Stitch Finisher) - Sharp AR-350 Operation Manual

SADDLE STITCH FINISHER
Troubleshooting (concerning the saddle stitch finisher)
Check the list below before contacting the SHARP Service Center.
Problem
GStapling position not set properly in the
Stapling position
is not correct stapling setting?
(including saddle
stitch).
GThe top cover or the front cover of the
The saddle stitch
finisher does not saddle stitch finisher open?
GMessage indicating need to remove
operate.
paper from the stapler compiler
displayed?
GMessage requesting check for the
Stapling cannot
be performed staple unit displayed?
GMessage requesting adding staples
(including saddle
stitch).
displayed?
GDifferent size paper included?
GPaper heavily curled?
GPunch function set properly in
Punch position is
not proper.*1 accordance with the punch position?
GMessage requesting check for punch
Cannot be
punched.*1 module displayed?
GDifferent size paper included?
GPaper heavily curled?
GPamphlet copy set?
Not properly
arranged if the
saddle stitch
function is used in
the copy mode.
*1 When a punch unit is installed as a peripheral unit
5-26
Solution
Check the stapling position setting. (See page
xx.)
Close all covers. (See pages xx and xx.)
Remove all remaining paper from the stapler
compiler referring to step 3 on page xx.
Remove jammed staples. (See page xx.)
Replace the staple cartridge. (See page xx.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Check the punch position and set it again. (See page
xxxx.)
Dispose of punch scraps. (See page xxxx.)
Punching cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Set the pamphlet copy function and then perform
saddle stitch.