Mitsubishi Electric Melsec Q Series User Manual page 234

7
MES INTERFACE FUNCTION CONFIGURATION TOOL
(1) Execute program before action, or Execute program after action
(2) Program execution destination
(3) Command line (Up to 127 characters)
7
- 76 7.10 Job Setting
7.10.3 Setting items in Program execution
Figure 7.62 [Program execution settings after action execution]
Table 7.56 Setting items when selecting [Program execution settings before action execution] or
[Program execution settings after action execution]
Item
Execute program before
(after) action
Program execution
destination
Command line
Check return value
Wait for execution
completion
(a) Set whether or not to enable program execution before or after execution of
actions.
(b) When [Execute program before action] or [Execute program after action] is
enabled, make the setting described in (2) and subsequent sections.
Select an application server to be accessed.
Enter a command line for the program that is executed on the application server
*1 *2
computer.
For characters that can be used for command lines, refer to the following:
Appendix 2.3 Characters available for character string constants, etc.
*1 Programs that need to be run with administrator privileges (by a user in Administrators group) are
not executable.
*2 To execute a program including any displays, place the application server computer into the logon
status.
Set whether or not to enable program execution before or after execution
of actions.
Select an application server to be accessed.
Enter a command line for the program that is executed on the application
server computer. (Up to 127 characters)
Set whether to check the return value or not.
Set whether or not to wait for execution completion of the program before
executing the next processing.
Description