4
SETTINGS AND PROCEDURE TO OPERATION
(3) Removing a CompactFlash card
CompactFlash card slot
Remark
4
- 19
4.7 CompactFlash Card
4.7.2 Installation/removing the CompactFlash card
1
Open the LED cover on the front of the MES interface module, then remove the
CompactFlash card.
EJECT button
PULL
CF CARD
10BASE-T/
100BASE-TX
100
M
SD/
RD
QJ71MES96N
Figure 4.16 CompactFlash card removal
• Put the finger at the bottom of the LED cover that is on the front of the MES
interface module, and lift the LED cover to open.
• When ejecting the CompactFlash card from the MES interface module, press
the EJECT button to push the CompactFlash card out.
When having difficulty in replacing the CompactFlash card, the following tweezers
are available.
Product: Plastic tweezers
Model name: NK-2539
Figure 4.17 Replacing the CompactFlash card using Plastic tweezers
2
Attach the CompactFlash card slot cover and close the LED cover on the front of
the MES interface module.
• Attach the CompactFlash card slot cover.
When the CompactFlash card is not installed, attach the CompactFlash card
slot cover.
• Lower the LED cover on the front of the MES interface module until it clicks.
LED cover
EJECT button
Press
Remove in this
direction.
CompactFlash card