Messages And Signals - Sharp UX-300 Operation Manual

Messages and Signals

Display messages
Note: If you have turned on the Caller ID function, see Caller ID in
Chapter 7 for display messages related to Caller ID.
CHECK PAPER SIZE
COVER OPEN
DOCUMENT JAM
FAX RX IN MEMORY
FILM END
FUNCTION MODE
HOLD
LINE ERROR
LINE IS IN USE
The paper size setting is incorrect. Change the paper
size setting as described in Loading the Paper in
Chapter 1.
The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment cover to close
it.
The original document is jammed. See the following
section, Clearing Paper Jams .
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The imaging film may need replacement. Check the
film and replace if necessary.
The FUNCTION key has been pressed.
The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH again to take the other
party off hold.
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see Line Error in Problems and
Solutions in this chapter.
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
Display Messages
111