Terminal Configuration - VeriFone VX690 User Manual

2.8

Terminal configuration

Connecting base station to power
Once the Live eftpos integrated terminal is connected, the Merchant ID and Terminal ID will
need to be entered into the PC-EFTPOS EFT Client.
This work will be completed by a technician at the time of configuration.
You can use the function on the keypad from the terminal idle screen to configure the
primary communications method. To do this, press the # key at the idle screen and enter 998
to proceed to communications selection.
The following configuration options will be displayed:
1. Bluetooth Base: View the details of the connected Bluetooth base hardware, and press
"1" to unpair from the base so that your terminal can be paired with another base.
2. Bluetooth Base Version: View the firmware version of the connected Bluetooth base,
and press "2" to update the base firmware if required.
3. POS Details: View details on the POS interface methodology (such as RS232).
4. SIM: Press "4" to verify the SIM details (if installed).
5. PSTN Details: Press "5" to verify the PSTN phone number (if in use).
6. Power off timer: Press "6" to configure the power-off timer duration.
7. (not in use).
8. Internal Modem: Press "8" to configure which communications method should be used
to communicate with Live eftpos in the event that POS Communications are down. The
available options are GPRS, PSTN, and None.
Note that these communications method configurations are for the handset communicating
directly with the host (via GPRS or PSTN) in the event that the POS-to- Bank link is down.
The host communications (GPRS or PSTN) will only be used in the event that the POS
communications to Live eftpos are (and/or the terminal is in standalone lite mode), and this
process should be seamless during a transaction.
10
Live eftpos integrated User Guide