Battery Removal And Installation; Battery Removal; Proper Battery Disposal; Battery Installation - Supermicro X11SCZ-F/Q User Manual

Super X11SCZ-F/Q User's Manual

3.4 Battery Removal and Installation

Battery Removal

To remove the battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Remove the battery cable at the BT1 connector on the board.
3. Remove the battery.

Proper Battery Disposal

Please handle used batteries carefully. Do not damage the battery in any way; a damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.

Battery Installation

1. Unplug the power cord.
2. Connect the battery into the battery connector (BT1) and push it down until you hear a
click to ensure that the cable is securely locked.
3. If using the extended CMOS battery connector, connect the battery cable to J18 and
ensure the connection is secure. Use the foam tape on the back side of the battery
to secure the battery to a flat surface on the bottom of the motherboard or a proper
location in the system. DO NOT place the battery on the heatsink.
Battery Connection for J18 Standard Battery Holder for BT1
66
OR