Table of Contents
Advertisement
ANNEX
Add a drive and axis OFFLINE
■ Creating the EtherCAT Network Configuration
1.
Double-click EtherCAT under Configurations and Setups in the Multiview Explorer.
The EtherCAT Tab Page is displayed in the Edit Pane.
2.
Drag the Drive from the Toolbox to the master on the EtherCAT Tab Page
The Servo Drive is added under the master with a node address of 1.
Additional Information
If the physical EtherCAT network configuration is already connected, you can automatically create
the virtual network configuration in the Sysmac Studio based on the physical network configuration.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for specific procedures.
42
Advertisement
Table of Contents
