■ Motor installation
1.
Please handle the motor carefully &
transport, installation, or removal of the motor.
2.
Please fixe and connect the motor to the mechanical system
Note: At first, please check motor operation without any load.
3.
Please attached the power and encoder cable
Here is an example with 200W motor
Please tight screws in several times in this order :1>4>3>2
Additional Information
For further details about coupling method, please refer to 1S-series AC Servomotors and Servo Drives
User's Manual (with Built-in EtherCAT Communications) (Cat. No. I586)
■ Wiring
1.
Overview
For further details please refer to section 4-2 wiring of 1S AC servo drive user's manual
(Cat. No. I586)
18
(step 2, 3 order depends on your mechanical implementation)
do not apply heavy impacts or loads during