How To Use A Fluke Networks Ibc Oneclick Cleaner - Fluke CertiFiber Pro User Manual

CertiFiber Pro Fiber Optical Loss Test Set
Users Manual
How to Use a Fluke Networks IBC OneClick
Cleaner
To prevent damage to the device and to connectors
and to keep contamination off of endfaces, read all
instructions and obey all safety precautions given in
the instructions for the device you use to clean
connectors.
To clean the connectors on test reference cords, use
wipes and solvent. The OneClick cleaner cleans the
fiber core, but can leave contamination around the
core. The contamination can move to the core when
you make connections. See "To Clean Connector
Ends" on page 39.
1 Use the video probe to inspect the connector. If it is dirty,
continue to step 2.
2 To clean a bulkhead connector, remove the cap. To clean the
connector on a fiber cable, remove only the tip of the cap.
3 If necessary for a bulkhead connector, extend the tip of the
device.
4 Push the device straight into the connector until you hear a
loud click. See Figure 13. Then remove the device.
5 Use the video probe to inspect the connector. If necessary,
clean and inspect the connector again.
If the mechanical device does not clean the connector
sufficiently, use a swab and solvent to clean the connector.
36

Caution