Fluke CertiFiber Pro User Manual page 127

The tester does not increment symbols or
accented characters.
When you use an ID set that does not have a Last ID, the set
under IDs Untested on the CHANGE ID screen shows only the
next ID.
Total IDs: The number of IDs in the set. This section does not

show for ID sets that do not have a Last ID.
Select Media: Select Fiber and Loss Length to use the ID set to

save results from tests on fiber cable. If you will do other fiber
tests on the IDs, also select those tests.
For example, you can specify that you must do a Loss Length
and a FiberInspector test for each ID. After you do both tests for
all the IDs in the set, the tester shows 100% Tested on the home
screen. If no IDs include FiberInspector results, the tester shows
50%. To see the IDs that need FiberInspector results, select a
FiberInspector test in the project, then look at the list under
FiberInspector IDs Untested on the CHANGE ID screen
If you select Copper, the ID set will not be
available when you do a fiber test.
The Select Fiber Tests section does not show for ID
sets that do not have a Last ID.
Tap IMPORT to use an ID set that you downloaded to the tester

from LinkWare software.
 Tap REVIEW to see the CABLE ID REVIEW screen, which shows
the ID set an the total number of IDs.
The REVIEW button does not show if you do not
enter a Last ID.
SAVE: To save the ID set, tap SAVE.

Note
Notes
Note
Chapter 8: Projects
About Next ID Sets
117