Table of Contents
Advertisement
Sewing
on Buttons
Pattern selector:
C
_2_Presser foot:
Zigzag foot
_3_Thread tension:
1-3
_4_Stitch length:
Any
Stitch width:
Adjust as necessary
_6_Feed dog:
Dropped
L
F
®
®
®
,_2--3-_
0/t
4%5
II11Adjust the stitch width, and turn the handwheel to check
if the needle enters into each hole on the button.
121Lower the foot to hold the button in place.
The holes on the button should align with the slot of the foot.
131A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both holes
on the button.
Sew about 10 stitches and cut the needle and bobbin
threads, leaving 20 cm (8") tail.
1411 B ring the needle threads between the button and fabric
through the holes on the button.
Pull the needle threads to pick bobbin threads up to
the right side of the fabric.
Wind the threads to from a shank and tie them together.
151Raise the feed dog after sewing.
[]
/
42
Hide quick links:
Advertisement
Table of Contents
