Table of Contents
Advertisement
F G H
1
G
4
2
3
20
Sewing Buttons
1
Stitch selector:
F - H
2
Presser foot:
Zigzag foot
3
Thread tension:
1-3
4
Feed dog:
Dropped (See page 16 ).
Tape the button over the placement mark.
A pin can be placed on top of the foot to from a shank.
Set the pattern selector at "F, G or H".
Align both holes of the button with the slot of the foot
and place the left hole of the button just below the
needle point.
Lower the foot and turn the pattern selector until the
needle point comes just above the right hole of the
button.
Sew about five stitches and raise the needle.
To strengthen the shank, cut the threads leaving a
20 cm (8") tail.
Bring the needle thread down through the hole in the
button and wind it around the shank.
Draw the thread to the wrong side and knot.
Advertisement
Table of Contents
