Using The Seam Guides On The Needle Plate; Turning Square Corners; Variable Needle Position - Janome 385.4052LX200 Owner's Manual

Using the Seam Guides on the Needle Plate
The seam guides on the needle plate help you to measure seam
width.
* The numbers indicate the distance between the center
needle position and the guide line.
Guide lines
(2) Cornering guide
(3) Needle plate
_4_Needle plate hole
(5_ Seam width from the center needle position
Turning Square Corners
To turn a square corner 1.6 cm (5/8") from the fabric edge.
When the fabric edge facing you lines up with the cornering guide
as illustrated, stop stitching and lower the needle by turning the
handwheel towards you.
Raise the presser foot and turn the fabric to line the edge with the
1.6 cm (5/8") seam guide.
Lower the presser foot and begin stitching in the new direction.
(2) Cornering guide
®
Variable Needle Position
When the straight stitch (pattern A) is selected, you can move
the needle between center and left needle position by turning
the stitch width dial.
_0 1 2 3 4 5_
34