Sewing On Buttons - Janome 2200XT Instruction Manual

@
CD
c
�
C//11 r,,,�
' ' f "
I>
..; , _
�
"'
•U
lTl [2J
®i
@
\
;;. ,
I
J
' �
�

Sewing on Buttons

CD Pattern selector:
@ Presser foot:
® Thread tension:
@
Stitch length:
®Feed dog:
ITl
Adjust the stitch width, and turn the
handwheel to check if the needle enters into
each hole on the button.
[I]
Lower the foot to hold the button in place.
The holes on the button should align with the
slot of the foot.
[]]
A pin can be placed on the foot to form a
shank.
Make sure to check if the needle enters into
both holes on the button.
Sew about 10 stitches and cut the needle and
bobbin threads, leaving
Q]
Bring the needle thread between the button
and fabric through the holes on the button.
Pull the needle thread to pick bobbin thread
up to the right side of the fabric.
Wind the threads to from a shank and tie
them together.
[fil
Raise the feed dog after sewing.
17
c
Zigzag foot
1- 3
Any
Dropped
cm (8 ' ' ) tail.
20