Table of Contents
Advertisement
q
w
r
y
Sewing Buttons
e
q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
t Stitch width:
y Feed dog:
t
Drop the feed dogs (See page 14). Match the
holes in the button with the horizontal slot on the
presser foot. Adjust the stitch width matching the
distance of the holes in the button. Lower the
foot to hold the button in place. Check to see if
the needle enters into the holes in the button by
turning the handwheel by hand. Sew about ten (10)
stitches.
To strengthen the shank, cut the threads leaving
about 4˝ (10.0 cm). Bring the needle thread down
through one of the holes in the button and wind it
around the shank. Bring the needle thread to the
wrong side (bottom side) and knot.
After button sewing is completed, raise the feed
dogs for normal sewing.
22
C
Zigzag foot
3–7
Any
Adjust as necessary
Dropped
Advertisement
Table of Contents
