Table of Contents
Advertisement
Some features/menus are operator dependent
Select the Microsoft Infrared Support for Windows ver-
sion 1.0.
Press Add/Remove.
Press OK.
Go to 'Step 3 – Install Infrared Support' to continue the in-
stallation of the infrared modem.
Step 3 – Install Infrared Support
Insert the CD into your computer's CD drive or the
diskette containing the Infrared support into the disk-
ette drive.
If you are using a diskette or if your CD does not start
automatically, select 'Run' in the 'Start' menu. Type
A:\setup if you are using diskettes or D:\setup if you
are using a CD (could be another drive). Press OK.
When the Setup dialogue appears on the screen, press
the Install Infrared Support for Windows 95 version 2.0
button.
Follow the instructions given on the screen
When the Add Infrared Device Wizard appears, select
the Built-in infrared port on laptop or desktop and
press Next.
When the next page of the Wizard appears on the
screen, select the COM port enabled for infrared com-
munication and press Next.
When the third and last page appears on the screen, ac-
cept the default settings by pressing OK.
After the installation you will return to the Setup dialogue
where you can continue the installations with Step 4 – Install
Infrared Modem:
30
Step 4 - Install Infrared Modem
Insert the CD into your computer's CD drive or insert
the diskette into the diskette drive.
Place the phone with the infrared modem next to your
PC as in the illustration below. (The infrared port may
be positioned differently on your computer.)
Close the Control Panel if it is open.
Open the Control Panel.
Double press the Infrared Monitor icon.
Select the Options tab and make sure that the check
box 'Enable infrared communication on:' is checked. In
most cases the infrared communication is enabled on
COM2 or COM3.
To check that the infrared communication is enabled, press
Tip!
the Status tab. The message One infrared device
is in range should be displayed. Your computer will
now discover the new hardware and a dialogue box will ap-
pear.
Press Next.
When the next dialogue box appears select the drive
and folder containing the modem script. Select A: if you
Advertisement
Table of Contents
