Ericsson CF888 User Manual page 23

Some features/menus are operator dependent
To save the number in the phone memory, in a position
you decide:
Press the navigation key
•
enter the position and then press
If you have entered a number in the scratch pad during a call,
Tip!
you can store it in the Phone Book by selecting Store from
the Phone book menu while you have the number in the
display.
Overwrite Protection
If you try to store a phone number in a position which already
contains a phone number, the message Used Over-
STORE 2
Used
write? appears in the display. You then have the two
Overwrite?
following options.
To store the number in a different position:
Press .
NO
Enter the new position number.
Press
YES
To store the number in the selected position, thus erasing the
old number:
Press .
YES
When the Memories are Full
If you try to store a phone number when all the positions
in the card memory are occupied, a position number in the
phone memory will be suggested in the top line of the dis-
play.
If both memories are full, no position number will be
suggested. If you still wish to store the phone number,
you have to enter the number of an already occupied po-
sition, thus erasing the old number.
18
, press the # key once,
RIGHT
.
YES
STORE
e: Bankbyphone
Recalling a Phone Number
Storing a Number With a Tone Signal Code
In order to, for example, perform banking by phone or con-
trol a phone answering machine, you will need to use codes.
These codes are sent as tone signals (also called DTMF
tones).
Anything entered after a pause is sent as DTMF tones from
Note!
the Phone Book.
If you want to save the phone number in the Phone Book to-
gether with the codes:
Follow the instructions on how to store a phone
number until entering the number.
After you enter the phone number, press and hold the
* key until the pause character 'p' appears.
34
Enter the code.
040556677p_
If needed, insert another pause, another code and so on.
Continue following the instructions on how to store a
phone number.
When you make the call, the phone will dial the number, wait
until the call is answered and send the code. If you inserted
another pause and another code, it will pause again, send the
next code and so on.
The Speed Dialing Facility
You can call the phone numbers that you store in the posi-
tions 1 – 9 in the card memory by entering the position number
and then pressing . Therefore, you should save positions
YES
1 – 9 for important numbers.